Mineral slag dryer is widely applied for  buildingmaterial, metallurgy, and beneficiation, chemical engineering, andcement industries. slag dryer has been verified by the commercial plantlifting flights with optimal design make the head and mass transfer morecomplete,increase evaporation rate and productivity, the cylinder isflanged connection,with good alignment,convenient for transportation andinstallation.The drying machine can be used for drying of mineral slag,limestone, clay, river sand, quartz sand, carbide slag, and grain slag.The mineral slag dryer is applicable for many combustion furnace suchas high temperature fluidized bed furnace, coal dusting furnace andmanual coal adding stove.

1. The material is sent to hopper by belt conveyor or bucket elevator,and then enter into the feed end by the charging pipeline of the chargerin hopper.
2. The charging pipeline gradient of fluorite dryer equipment should bebigger than the natural gradient of material so that the material canenter into the dryer smoothly.
3. The dryer cylinder is a spin cylinder of little tilt to thehorizontal line. Material goes in from the higher end, the heat-carryingagent enters from the lower end contacting with the material incountercurrent way. The wet-material is heated directly or indirectly bythe heat-carrying agent during its moving forward process in thefluorite dryer equipment, and thus it is dried.
4. Then it is sent out by belt conveyor or spiral conveyor on the discharge end.
5. There is shoveling plate on the fluorite dryer inner wall, liftingand dropping the materials to enlarge the contact surface of materialand air current and speed up the drying process and promote the materialmoving forward. The heat-carrying agent can be divided into hot air andflue gas.
6. After the heat-carrying agent entering into the dryer, cyclonecollector is needed to gather the material in the air. To further reducethe dust load in tail gas, the bag filter or dust washer is needed.

This drying equipment makes great changes in the lift flitch devices,adopting new type multi-combination type which solves the wind tunnelphenomenon of the traditional dryer and is of high heat efficiency. Thecoal consumption is decreased by 20%.
1. High thermal efficiency
2. Low temperature in outlets
3. Alloy steel plate or stainless steel plate
4. Convenient transportation

Mineral slag dryer production line consists of rotation barrel,induced air equipment, high speed scattering equipment, automaticcleaning device, transmission device, conveying device, blast heater,speed reducer, supporting device and sealing devices. The whole setdrying equipment is of high output, low energy consumption, reasonabledesign, fine making, stable property, advanced technology, small floorarea, and high mechanic degree.