Experts of Zhengzhou Dehong Machine Manufacturing Co., Ltd. remind you that in the development of assembly operations in order to avoid possible accidents, safety measures must be taken, lifting operations of the command, the key parts of installation operating procedures, special precautions. On the working site, you should take preventive measures on electrical wiring, plumbing and other possible hidden dangers of accidents .

      Therefore, only do the preparatory work to follow the installation procedures and processes of the Dryer machine specific installation and installation:

1.Base crossed:
First laid Center Standard boards, reference point, as the equipment is installed and find a basis for future maintenance. Determine the basis of industrial drying machine both ends of the center, draw the basic longitudinal centerline, draw the horizontal center line of the file, and the axial center line of gear. When some or most or the subdivision by foot moved aside hole is too large, may consider the extent permitted by the appropriate mobile center line position, to facilitate the work of most of the reserve hole into position coordinates. After adjusting the center of each file must be in a vertical center line, horizontal center line must be perpendicular to the longitudinal centerline, the longitudinal centerline horizontal distance must be measured center distance of the file consistent.

2. Set of industrial drying machine plate:
Identification plate of the rational distribution, attention should be close to the bolt plate and arranged in the load center of gravity position to prevent the plate Shouli Bu all. Each number plate shall not be more than five, put down a thick plate, thin up the middle, good contact with a neat pile, when the adjustment can not completely overlap, the contact area should be greater than 80%. The bottom plate should have sufficient contacts with the basic accuracy with basic access to dense, place a smooth, sway angle of the phenomenon may not be free and to ensure that plate up and down in the vertical direction based on gradient and the same direction transverse to the basic level.

3.Industrial drying machine base crossed:
Optical theodolite, laser collimator or a precision less pull method for horizontal leveling roller base to find positive vertical slope to find repeated several times, until the coordinates of the location, the horizontal level, vertical gradient to meet the requirement shall prevail.

4. Industrial drying machine and then after each two-wheel base overall bit alignment. Around the longitudinal centerline of the base must be along the same line, the error small 0.5MM. With these adjustments can be the base for both ends of the adjusting screw with.

      For more information or to purchase, please contact Zhengzhou dehong Machinery Equipment Co., Ltd.. Tel :+86-371-0371-67107188 67826037 67842719 Fax :+86-371-67842719